This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
designs:emumini2:demopartslist [2015/09/25 13:46] raymondsheh created |
designs:emumini2:demopartslist [2015/09/25 19:38] raymondsheh |
||
---|---|---|---|
Line 8: | Line 8: | ||
== Camera == | == Camera == | ||
- | * Raspberry Pi camera. One of the following: | + | * 1x Raspberry Pi camera - [[http://www.aliexpress.com/item/Raspberry-Pi-Camera-Board-w-M12x0-5-mount-LS-40180-Fish-Lens-fully-compatible-with-official/2026953136.html|After-market fisheye Raspberry Pi camera]] |
- | * Recommended: 1x [[http://www.aliexpress.com/item/Raspberry-Pi-Camera-Board-w-M12x0-5-mount-LS-40180-Fish-Lens-fully-compatible-with-official/2026953136.html|After-market fisheye Raspberry Pi camera]] | + | |
* Alternative: 1x Original Raspberry Pi Camera (Element14 2302279) | * Alternative: 1x Original Raspberry Pi Camera (Element14 2302279) | ||
* Raspberry Pi camera 2ft (60cm) extension cable | * Raspberry Pi camera 2ft (60cm) extension cable | ||
Line 15: | Line 14: | ||
== Radio == | == Radio == | ||
- | * USB Wireless LAN adapter, soft-AP compatible. One of the following: | + | * 1x USB Wireless LAN adapter, TP-Link TL-WDN3200 802.11a/b/g adapter. |
- | * Recommended: 1x TP-Link TL-WDN3200 802.11a/b/g adapter. | + | |
* Alternative: 1x Raspberry Pi WiFi (Element14 2301652, AdaFruit 814) | * Alternative: 1x Raspberry Pi WiFi (Element14 2301652, AdaFruit 814) | ||
- | == Connectors == | + | == Connectors and Cables == |
- | * Connectors for OpenCM9.04-A. One of the following: | + | * 4x Connectors for OpenCM9.04-A. [[http://au.element14.com/webapp/wcs/stores/servlet/ProductDisplay?catalogId=15001&langId=43&urlRequestType=Base&partNumber=9979620&storeId=10184|Molex 3-pin 22-03-5035 Wire-To-Board Connector SPOX 5267 Series (Element 14 9979620)]] |
- | * Recommended: [[http://au.element14.com/webapp/wcs/stores/servlet/ProductDisplay?catalogId=15001&langId=43&urlRequestType=Base&partNumber=9979620&storeId=10184|4x Molex 22-03-5035 Wire-To-Board Connector SPOX 5267 Series (Element 14 9979620)]] | + | |
* Alternative: 1x Robotis OpenCM9.04-Accessory Set | * Alternative: 1x Robotis OpenCM9.04-Accessory Set | ||
* 5x Robotis Robot Cable-3P 200mm | * 5x Robotis Robot Cable-3P 200mm | ||
* 3x Robotis Robot Cable-3P 140mm | * 3x Robotis Robot Cable-3P 140mm | ||
+ | * 1x 50cm length of 5A hookup wire | ||
+ | * 1x 10cm length of 5mm diameter heat shrink tubing | ||
== Motors == | == Motors == | ||
Line 37: | Line 36: | ||
* 1x LiPoly 3 cell low voltage alarm board | * 1x LiPoly 3 cell low voltage alarm board | ||
* 1x 5A SPST main power switch | * 1x 5A SPST main power switch | ||
- | * Raspberry Pi power. One of the following: | + | * 1x Set of components to power off the LiPoly battery, including external power jack. |
- | * Recommended: Power off the LiPoly battery, including external power jack, with the following components. | + | |
* 1x 2A 5V Voltage Regulator (RC Battery Eliminator) | * 1x 2A 5V Voltage Regulator (RC Battery Eliminator) | ||
* 1x 5A SPST power switch to isolate motors | * 1x 5A SPST power switch to isolate motors |