This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
designs:emumini2:parts [2015/05/07 02:25] raymondsheh |
designs:emumini2:parts [2015/09/25 11:52] raymondsheh |
||
---|---|---|---|
Line 10: | Line 10: | ||
* Mobile phone emergency charger, $10 AUD | * Mobile phone emergency charger, $10 AUD | ||
* XT-60 battery connector, $1 AUD | * XT-60 battery connector, $1 AUD | ||
- | * Nuts, Bolts, Wire, Misc components, $5 AUD | + | * [[designs:emumini2:fasteners|Nuts, Bolts, Wire, Misc components]], $5 AUD |
* 3D printed plastic components, $5 AUD | * 3D printed plastic components, $5 AUD | ||
- | Additional recommended components (TOTAL: $110): | + | Additional recommended components (TOTAL: $106): |
* PiTFT screen, $60 AUD | * PiTFT screen, $60 AUD | ||
* DC barrel connector, $3 AUD | * DC barrel connector, $3 AUD | ||
- | * 12V power adapter, $22 AUD | + | * 12V power adapter for running off mains during development, $22 AUD |
- | * Bluetooth adapter, $5 AUD | + | * 2x 1n4004 diodes to prevent backcharging, $1 AUD |
- | * Playstation controller, $20 AUD | + | * TP-Link TL-WDN3200 802.11a wireless LAN adapter, $29 AUD |
+ | * 2A 5V Voltage Regulator (RC Battery Eliminator), $6 AUD | ||
+ | * (Remove mobile phone emergency charger), -$10 AUD | ||
+ | * (Remove Wireless LAN adapter), -$5 AUD | ||
- | + | The specific parts list for the demo kit is available [[designs:emumini2:demopartslist|here]]. | |
- | + | ||
- | + | ||
- | + | ||
- | OLD parts list (TOTAL: $495 AUD): | + | |
- | * 7x Dynamixel AX-12A servos, $345 AUD | + | |
- | * Raspberry Pi 2B, $43 AUD | + | |
- | * Raspberry Pi camera, $39 AUD | + | |
- | * Raspberry Pi camera extension cable, $5 AUD | + | |
- | * Wireless LAN adapter, $5 AUD | + | |
- | * 8GB MicroSD card, $6 AUD | + | |
- | * 5V regulator (RC UBEC), $5 AUD | + | |
- | * OpenCM 9.04 board, $26 AUD | + | |
- | * 3 cell LiPoly battery, $10 AUD | + | |
- | * XT-60 battery connector, $1 AUD | + | |
- | * Nuts, Bolts, Wire, Misc components, $5 AUD | + | |
- | * 3D printed plastic components, $5 AUD | + |